HunterLab ColorFlex EZ User Manual page 18

ColorFlex EZ User's Manual Version 2.2
Figure 17. Product Setup Selection
Figure 18. Product Setup Confirmation
If YES is chosen, the Select setup to configure screen is shown. Move the cursor highlight to the
desired setup by using the up and down arrow buttons or by scrolling through the pages using
the right arrow button (Page). Then press the GO button to select it.
The screen that allows configuration of the setup selected (or the last setup used ) appears
next.
Configure each desired parameter by moving the cursor highlight to its position using the UP
and DOWN arrow buttons. When the parameter is highlighted, press the RIGHT arrow button
to scroll through the available choices for the parameter. When the choice desired is displayed,
stop scrolling. More parameters may be configured in this same manner.
When all parameters are set, press the GO (Main Menu) button to accept the settings and
return to the main menu or LEFT arrow (Back) to select another setup to configure.
Setups may be saved to a USB drive and uploaded into other instruments of the same model or
to the EasyMatch QC Software. The product setups are saved as ASCII Hex (.stp)
The product setup parameters that may be configured are as follows:
18