HunterLab ColorFlex EZ User Manual page 14

Place the standard or sample at the sample port with the side to be measured
4.
toward the port. Make sure that the item is flat against the port and completely
covers it.
Press the GO button to read. The standard or sample is read and its values (as
5.
configured in the product setup) displayed on the screen.
Note: If a bar code reader is installed, scan the bar code now, and the ID will
User options are shown on the keypad map at the bottom of the screen. Press
6.
SAVE/PRINT (down arrow) to both save the reading (if AutoSave is not enabled) in
the ColorFlex EZ's memory and print the reading if a USB printer is connected. The
saved readings counter in the upper left corner of the screen will be incremented to
reflect the newly saved reading. An example of a printout is shown.
14
ColorFlex EZ User's Manual Version 2.2
Figure 13. Place Standard at Port
Figure 14. Read
appear beneath the color measurement.
Figure 15. Printout