Colorflex Ez Installation; Install Easymatch Qc Software - HunterLab ColorFlex EZ Manual

The ColorFlex EZ is simple to set up and attach to your computer. Before operating the ColorFlex EZ
with EasyMatch QC, you need to install the batteries and connect the instrument to your computer.
These steps are outlined below.
Unpack the carrying case and remove wrappings and cable ties. Inspect for damage and
1.
notify the carrier and HunterLab immediately if any is discovered. Save the packing
materials in case it becomes necessary to return the instrument to the factory.
Plug the USB cable into the USB port on back left of the ColorFlex EZ.
2.
Plug the flat end of the USB cable into the appropriate USB port on the computer.
3.

Install EasyMatch QC Software

Complete the following steps:
Log into the system using an account that has ADMINISTRATOR privileges for the PC —
1.
network or local.
Insert the installation CD into the CD-ROM drive. If the system is setup to automatically
2.
run CD programs, the menu will appear, and you may skip to Step 5. Otherwise, continue
with Step 3.
Select the Easy Match QC Icon or from Windows, go to START > RUN >EZMQC_MENU and
3.
OPEN. The following screen will be shown.
4. Select INSTALL EASYMATCH QC SOFTWARE and follow the screen prompts.
5. Select SOFTKEY LICENSE as the type of key to use with the software.
ColorFlex EZ Supplemental Manual for EasyMatch QC Ver 1.2

ColorFlex EZ Installation

Figure 2. EasyMatch QC Installation
7