HunterLab ColorFlex EZ User Manual page 42

Scroll through the list of setups using the UP and DOWN arrow buttons until the
3.
setup is highlighted. Then press the center button GO to move to that setup.
The first reading screen appears, to place the standard for reading 1 of n (if the
4.
product setup uses a working standard) or sample for reading 1 of n.
Place the standard or sample at the sample port with the side to be measured
5.
toward the port. Make sure the item is flat against the port and completely covers it.
Press the GO button to read. The standard or sample is read and its values (as
6.
configured in the product setup) displayed on the screen.
Press SAVE/PRINT (down arrow) to both save the reading in the ColorFlex EZ's
7.
memory and print the reading if a USB printer is connected.
Press GO to make the next reading in the averaging sequence. (Rotate or reposition
8.
the sample before doing so.)
After all readings in the averaging sequence have been made press SAVE/PRINT
9.
(down arrow) to both save the reading in the ColorFlex EZ's memory and print the
reading (if a USB printer is connected).
42
ColorFlex EZ User's Manual Version 2.2
Figure 62. Select Setup
Figure 63. Place Sample at Port
Figure 64. Reading with Averaging