Omron sysmac EtherCAT NJ101 Series Connection Manual page 20

7.3.2. Setting the EtherCAT Network Configuration
Set the EtherCAT network configuration.
1
Turn ON Controller and Dry
Vacuum Pump.
2
Select Communications Setup
from the Controller Menu.
3
The Communications Setup
Dialog Box appears.
Check that Direct connection via
Ethernet is selected in the
Connection type Field.
Click OK.
4
Select Online from the
Controller Menu.
*If the dialog box on the right
appears, check the message
and click OK. Then select
Online again.
*If the dialog box on the right
appears, check the message
and click Yes.
*The message of the dialog box
varies with the Controller
status. Check the message
and click on an appropriate
button to proceed with the
processing.
5
When an online connection is
established, a yellow line
appears under the toolbar.
7．EtherCAT Connection Procedure
17