Device Configuration - Omron sysmac EtherCAT NJ101 Series Connection Manual

5.2. Device Configuration

The hardware components to replicate the connection procedures in this guide are as follows:
PC
(Sysmac Studio installed,
OS: Windows 10)
LAN cable
Manufacturer
OMRON NX-series CPU Unit
(built-in EtherCAT port)
－
Power supply
(24 VDC for Controller)
OMRON Sysmac Studio
－
PC (OS: Windows 10)
－
LAN cable (STP (shielded,
twisted-pair) cable of Ethernet
category 5 or higher)
OMRON Ethernet cable (with industrial
Ethernet connector)
Kashiyama Dry Vacuum Pump
Kashiyama Handheld Controller
Kashiyama ESI file
Precautions for Correct Use
Contact Kashiyama Industries, LTD. to obtain the ESI file specified above before proceeding.
Precautions for Correct Use
The connection line of EtherCAT communications cannot be shared with other Ethernet
networks. Do not use devices for Ethernet such as an Ethernet switch. Use an Ethernet cable
(double shielding with aluminum tape and braiding) of Category 5 or higher, and use a
shielded connector of Category 5 or higher.
Connect the cable shield to the connector hood at both ends of the cable.
5．Applicable Devices and Device Configuration
NX102-1200
(built-in EtherCAT port)
Power
supply
Ethernet cable
Name
EtherCAT Interface
Dry Vacuum Pump
(EtherCAT Interface E-CAT02)
(e.g. SD series)
Model
NX102-1200
－
SYSMAC-SE2□□□
－
－
XS5W-T421-□M□-K
－
E-CAT02
－
KASHIYAMA_ECAT02_Rel
ease_V0100.xml
Handheld
Controller
Version
Ver.1.42
Ver.1.43
Rev.
0x00000100
6