Adjustment - Luna BTS 315 User Manual

4.47 Rip fence precision adjustment
Tools Required for Assembly:
• 16 mm fork wrench.
• Let B, C, D go through the frame, then fix on A
(Don't fix too tight, there are 2 sets).
• Let the sliding table go through A, then align the sli-
ding table to the frame according to E sticker.
• Position the sliding table towards the saw unit and
fix the position. Then tighten the screw.
A
B
C
D
Fig. 4.4.7

5. ADJUSTMENT

Handle the tools with protective gloves.
5.1 Scorer adjustment
CAUTION
For cutting panels coated with finishingmaterial, you
have to use the scorer D. Position the scoring saw
blade in order to have an engraving equal to 2 mm.
Proceed as follows if it is necessary to adjust scorer
positioning with respect to the saw:
• Loosen the knob A, and then adjust scoring saw
height using the knob C.Lock the knob A.
• Loosen the knob B, and then adjust scoring saw
height using the knob D.Lock the knob B.
The nut at E has been adjusted and fixed correctly. No
random adjusting is permitted.
E
5.2 Extension table flatness adjustment
Tools Required for Assembly:
• Straight edge
• Feeler gauge
• L wrench 4mm
• Wrench 16mm
• Put the straight edge B on the main table and exten-
• Re-tighten the bolts A to micro-adjust the flatness.
5.3 Rip fence precision adjustment
Tools Required for Assembly:
• Straight edge, Angle gauge, Depth gauge
• Feeler gauge
• Wrench 18 mm
• Check the perpudicularity between the rip fence and
52
Fig. 5.1
sion tables, use feeler gauge to check the flatness.
A
B
Fig. 5.2
table with triangle compass and feeler guage. Loo-
sen 4pcs short shaft B, then adjust the guide rail up
and down to get best perpudicularity.
D
A
B
C
D
E
A
B