Luna BTS 315 User Manual page 51

C
B
A
4.3 Installation zone characteristics
It is prohibited to install the machine in explosive
environments.
The installation zone must be selected evaluating the
work space required depending on the dimension of
the pieces to be machined,and taking into account that
a free space of at least 800 mm must be left around
the machine.It is also necessary to check the floor
capacity and its surface, so that the machine base is
evenly resting on its four supports.A power outlet and
a chip-suction system connection shall be close to the
selected machine setting and it must be conveniently
lighted (luminous intensity: 500 LUX).
D
1000KG
E
Fig. 4.2
Fixing to the floor
The machine must be fixed to the floor.
• Use bolt/nut A to level the feet to ensure machine is
well located.
• Put expansion bolts D (not supplied) into ground,
use washer/lock washer C and hex nut B to fasten
the bolts.
A
4.4 Install of loose parts - introduction
A few elements will be disassembled from the
machine main structure due to packaging and shipping
requirements. These loose parts should be installed as
follows.
Please tighten all bolts and nuts absolutely. Otherwise,
may cause machine wobble or serious injury to the
operator or other persons.
4.4.1 Install extension table
Tools Required for Assembly:
• Wrench 16mm
• L Wrench 6mm
• Install Extension tables A to main table C with bolt 1
and washer 2.
• Install set screw 3 for micro-adjustment.
A C
1
2
3
4.4.2 Install blade guard and hose
support rod
Tools Required for Assembly:
• Wrench 13mm
• Philips screwdriver
50
B
C
D
Fig. 4.3
1
2
3
Fig. 4.4.1
B