Luna BTS 315 User Manual page 55

6.3.2 Working with rip fence
• Lock the sliding table. Put the workpiece against the
side surface of rip fence. Push the workpiece for-
ward across blade.
• For your safety, please use the plastic push block.
• When cutting off a small workpiece, please use the
push stick to prevent accident cutting of hands.
Fig. 6.3.2
6.4 Correct use for this machine
• First make sure that the machine does not vibrate.
Do not try to take off the material when the cut has
already started; proceed with a continuous and uni-
form speed. Workpiece feeding towards the blade
(especially where there are knots) should not be too
fast (feeding speed should be in accordance with
workpiece thickness). Do not let workpieces stop
between the saw fence and the blade.
• Avoid contact of the tips against metallic objects.
When necessary sharpen the saw blade.Often clean
the steel body and the tips with proper liquid pro-
ducts. Let the saw blade in the bath, then clean it
with brush: don't use metallic brushes. As regards
the toothing at least 2-3 teeth shall cut at the same
time A. If only one tooth cuts B, you don't get a
good cutting. Whenever this is possible, it is also
critical to lift the blade until the whole tooth cutting
part protrudes from the wood thickness.
Before touching the machine parts, ensure to turn OFF
the main switch and disconnect the general power
supply.
6.5 Cutting check after the machine
adjusting is finished
Before cutting workpiece, please make sure the
sliding table and fence is adjusted correctly. Choose
sharp and high-quality blade. Please choose a
1000mmX1000mm chipboard or destiny board. The
board thickness should be more than 19 mm. Put the
workpiece with the cutting side close to the fence, then
rotate the workpiece anticlockwise. Cut 10mm every
time, and cut 5times. Then check the width of the fifth
cutted woodpiece. The requested tolerance should be
within 0.2 mm.
3
54
A
B
Fig. 6.4
4
1、5
2
Fig. 6.5