Reference Manual
00809-0100-4803
3. Select the Custom Liquid (Density [T]) option.
4. Enter the Nominal and Operating Temperature Range. Engineering Assistant will
5. Select Next to continue the flow configuration on the Fluid Properties tab.
6. Enter the Custom Liquid Density at the given temperatures.
7. Enter the Reference Density at the reference temperature.
8. Enter the Custom Liquid Viscosity at the given temperatures. Note that all
9. Proceed with the steps in
2.5
Basic device configuration
Mass and energy flow Fast Keys
Direct process variable output Fast Keys
This section provides procedures for configuring the basic requirements to commission
the Rosemount 3051SMV. The Basic Setup tab, shown in
perform all of the required transmitter configuration. The complete list of Field
Communicator Fast Keys for basic setup are shown in
Emerson.com/Rosemount
use this range to identify the temperature values at which the fluid properties are
required.
Note
All temperature values may be edited except the minimum and maximum
temperatures.
temperature values may be edited except the minimum and maximum
temperatures. The minimum and maximum values were set on the Fluid Selection
tab.
Figure 2-17: Custom Liquid (Density [T]) Fluid Properties Tab
Primary element
selection.
1, 3
1, 3
Field Communicator Fast
Configuration
October 2018
Figure
2-18, can be used to
Keys.
31