APRILIA TUONO V4 R 2010 Service Station Manual page 365

TUONO V4 R
•
Using a dial gauge, check that the ra-
dial (A) and the axial (B) eccentricities
of the rim do not exceed the limit value.
An excessive eccentricity is usually
caused by worn or damaged bearings.
Replace the rim if, after replacing the
bearings, the value is not within the
specified limit.
Characteristic
Maximum radial and axial eccentricity:
0.8 mm (0.031 in)
Handlebar
pos. Description
1 Anti-vibration counterweight fastener
2 Throttle control fixing screw
3 Left light switch
4 Mirror supporting pin
5 Mirror supporting nut
H
ANDLEBAR AND CONTROLS
Type Quantity
M6 1
M5 2
M5 2
M10 2
M16x1 2
Suspensions
Torque
10 Nm (7.37 lbf ft)
6 Nm (4.42 lbf ft)
2 Nm (1.47 lbf ft)
40 Nm (29.50 lbf ft)
40 Nm (29.50 lbf ft)
Notes
-
-
-
-
-
SUSP - 365