TUONO V4 R
TABLE D
1. Speed sensor cable harness routing inside the
cable grommet and between throttle cables and
frame
•
Ensure that the cable grommet is not
interfering with the steering damper
during its movement
2. Right switch cable harness routing
3. Rubber clamp
4. Front stop switch cable harness routing
5. Main cable harness routing
TABLE E - INSTRUMENT HOLDER SUPPORT
•
First connect the regulator connector (1) and place it as shown in the figure
•
Connect the stop connector (2) and then the right light switch connector (3) and place them
as shown in the figure.
TABLE E1 - INSTRUMENT HOLDER SUPPORT
•
Place the branch (1) in the correspond-
ing tongues as shown in the figure
•
Fit the front ABS sensor (2) as shown
in the figure
•
Place the clamps (3) to then fasten the
main cable harness.
Electrical system
ELE SYS - 101