APRILIA TUONO V4 R 2010 Service Station Manual page 270

Engine
INSTALLATION
•
Install a new gasket in the head cover.
•
Smear the gasket with suitable seal-
ant, in the area indicated in the figure.
Recommended products
Three bond Sealing paste
-
•
Smear the head surface with suitable
sealant, in the area indicated in the fig-
ure.
Recommended products
Three bond Sealing paste
-
•
Fit the head cover.
•
Tighten the three screws with rubber washers to the prescribed tightening torque.
Front head
Removing camshafts
•
Remove both head covers, the alter-
nator side cover and remove the cap
on the clutch cover in order to rotate
the crankshaft.
•
Remove the O ring.
See also
Head cover removal
Removing the flywheel cover
ENG - 270
TUONO V4 R