Delta ASDA-A3 Series User Manual page 310

ASDA-A3
Set parameters for creating the E-Cam curve table:
4.
P5.094 = Motor gear teeth number (A) × Cutter number (C)
P5.095 = Cutter gear teeth number (B)
P5.096 =
�� × cutter diameter ��1(����)
1000000.
If V = 1, there is no speed compensation. If V
c
synchronous speed zone is 0.9 times of the master axis speed. If V
the cutter axis in the synchronous speed zone is 1.1 times of the master axis speed.
Enable Macro #6: write 0x0006 to P5.097 to enable Macro #6. Read P5.097 and if it
5.
returns 0x1006, it means using macro for table creation is successful. If any of the
following failure codes shows, modify the setting according to the description.
Failure code
0xF061
0xF062
0xF063
0xF064
0xF065
0xF066
0xF067
Cutting length ��(����)
× Cutter number �� × Speed compensation ��
When the clutch is engaged, the E-Cam table cannot be created.
Data of P5.094 exceeds the range (1 - 65535).
Cutter number set in P5.095 exceeds the range (1 - 65535).
Data of P5.096 exceeds the range (300000 - 2500000).
P5.081 data array start position exceeds the array length.
P5.082 E-Cam segment number must be set to 7.
The set values of P1.044 and P1.045 for the E-Gear ratio are too high.
Decrease the values of P1.044 and P1.045, but maintain the same ratio,
for example: adjust 167772160 : 1000000 to 16777216 : 100000.
= 0.9, the speed of the cutter axis in the
c
= 1.1, the speed of
c
Description
Motion Control
× 7
��
7-113