Load Working Modes; Lcd Setting - Epever SolarV TRIRON Series User Manual

parameters should be x2 for LFP8S.
When the battery type is "USE," the Lithium battery voltage parameters follow the
following logic:
A. Over Voltage Disconnect Voltage>Over Charging Protection Voltage(Protection Circuit
Modules(BMS))+0.2V;
B. Over Voltage Disconnect Voltage>Over Voltage Reconnect Voltage
Equalize Charging Voltage
Reconnect Charging Voltage;
C.
Voltage.
D.
Limit Voltage;
E. Boost Reconnect Charging voltage> Low Voltage Reconnect Voltage;
F.
The required accuracy of BMS is no higher than 0.2V. We will not assume
responsibility for the abnormal when the accuracy of BMS is higher than 0.2 v.
WARNING

5.2 Load working modes

5.2.1 LCD setting

1 DS1 module display and operation
Operation:
Step1: Press the
Step2: Long-press the
Step2: Press the
Step3: Press the
2 DS2 module display and operation
Copyright© 2022 SolarV GmbH All rights reserved.
button to switch to the load type interface.
button until the load type interface flashes.
button to select the load type.
button to confirm.
37
ing Limit
+0.2V