Load Output Voltage And Priority Setting - Epever MSC-N Series User Manual

A． Over Voltage Disconnect Voltage>Over Charging Protection Voltage(Protection
Circuit Modules(BMS))+0.2V;
B． Over Voltage Disconnect Voltage>Over Voltage Reconnect Voltage＝Charging
Limit Voltage ≥ Equalize Charging Voltage ＝ Boost Charging Voltage ≥ Float
Charging Voltage>Boost Reconnect Charging Voltage;
C． Low Voltage Reconnect Voltage > Low Voltage Disconnect Voltage ≥ Discharging
Limit Voltage.
D． Under Voltage Warning Reconnect Voltage>Under Voltage Warning Voltage≥
Discharging Limit Voltage;
E． Boost Reconnect Charging voltage> Low Voltage Reconnect Voltage;
F． Low Voltage Disconnect Voltage ≥ Over Discharging Protection Voltage
(BMS)+0.2V
 The voltage parameters of a lithium battery can be set according
 The required accuracy of BMS shall be no higher than 0.2V. We
WARNING

2.5 Load output voltage and priority setting

L2
L1
to the voltage parameters of the lithium battery BMS.
will not assume any responsibility for the system abnormal when
the accuracy of BMS is higher than 0.2 v.
Load 2
Output voltage
Load 1
Set to OFF
Set to ON
Set to OFF
15
Output 12V
Output 24V
Output 12V