Epever SolarV TRIRON Series User Manual page 36

Boost charging
14.4V
voltage (BCV)
Float charging
13.8V
voltage (FCV)
Low voltage
reconnect 12.6V
voltage (LVR)
Low voltage
disconnect 11.1V
voltage (LVD)
Lithium battery
protection NO
enable (LEN)
The SYS value can only be modified under the non-lithium "USE" type. The SYS value can be modified if the battery type is Sealed, Gel, or
Flooded before entering the "USE" type. The SYS value cannot be modified if it is a lithium battery type before entering the "USE" type.
Only the above battery parameters can be set on the local controller, and the remaining battery parameters follow the following logic. The
voltage level of the 12V system is 1, and the voltage level of the 24V system is 2.
4) Press the
next parameter.
9—17
5) Press the
9—17
current voltage value.
6) Press the
parameter(short press to increase 0.1V, long
9—17
press to decrease 0.1V).
7) Press the
next parameter.
9—17
Press the button to modify the switch status.
Note: It exists automatically from the current
YES/NO interface after no operation of more than 10S.
Copyright© 2022 SolarV GmbH All rights reserved.
button to confirm and enter the
button again to display the
button to modify the
button to confirm and enter the
32
the parameter.
4) Press the button to confirm and
enter the next parameter.
5) Press the button again to display the
current voltage value.
6) Press the or button to modify
the parameter(press
increase 0.1V, press
decrease 0.1V).
7) Press the button to confirm and
enter the next parameter.
Press the or button to modify the
switch status.
Note: It exists automatically from the
current interface after no operation of more
than 10S.
button to
button to