Epever SolarV TRIRON Series User Manual page 35

select the battery type as F04. And then, press the
button to confirm and go back to the battery voltage
interface automatically.
3) Long-press the
interface again on the battery voltage interface.
4) Press the
"USE."
Step2: Set the battery parameters on the local device. Under the "USE" interface, the battery parameters that can be local set are shown in the table
below:
Parameters Default
System
voltage level 12VDC
(SYS)
button to enter the battery-type
button to select the battery type as
Range DS1 module operation steps
1) Under the "USE" battery type, press the
button to enter the "SYS" interface.
12/24VDC
2) Press the
current "SYS" value.
3) Press the
Copyright© 2022 SolarV GmbH All rights reserved.
the
2) Press the
type, such as select the battery type as F04. And then
press the
automatically go back to the battery parameters setting
interface.
3) Long-press the
interface again on the battery parameters setting
interface.
4) Press the
type "USE."
button again to display the
button to modify the parameter.
31
button to enter the battery-type interface.
or button to select the battery
button to confirm. Continue to press the
button twice or wait for 10S of no-operation to
button to enter the battery-type
or button to select the battery
DS2 module operation steps
1) Under the "USE" battery type, press the
button to enter the "SYS" interface.
2) Press the button again to display the
current "SYS" value.
3) Press the or button to modify