Epever SolarV TRIRON Series User Manual page 30

Operation:
Step 1: On the initial interface, press the
the button to enter the PV parameters setting interface.
Step 2: Long-press the
Step 3: Press the
Step 4: Press the
5 Clear the accumulated electricity
Operation:
Step 1: On the initial interface, press the
the button to enter the PV parameters setting interface.
Step 2: Long-press the
flashes.
Step 3: Hold the
electricity.
Note: Return to the PV parameters interface to confirm whether the accumulated electricity
(kWH) is zero.
6 Local load type (with the RCS module)
Operation:
Step 1: On the initial interface, press the
press the button to enter the load parameters setting interface.
Step 2: Long-press the
Step 3: Press the
Step 4: Press the
NOTE: Please refer to chapter 5.2 for the load working mode.
Copyright© 2022 SolarV GmbH All rights reserved.
button to enter the LCD cycle time interface.
button or the button to set the LCD cycle time.
button to confirm.
button to enter the LCD cycle time interface, and the cycle time
button and the
button to enter the load type interface.
or button to change the load type.
button to confirm.
button to browse the PV parameters. Then, press
button to browse the PV parameters. Then, press
button for 5 seconds to clear the accumulated
button to browse the load parameters. Then,
26