ECOTEST MKS-UM Operating Manual page 80

2.3.6.10.3 Submode of the control unit "Measurement results clearing from
the nonvolatile memory"
2.3.6.10.3.1 To proceed to the submode of measurement results clearing from
the nonvolatile memory, press UNITS/CLEAR and hold it down (about 4 s) until
"CLr" symbols appear on the LCD (Figure 2.38). After that release UNITS/CLEAR.
(Submode of measurement results clearing from the nonvolatile memory)
You should finally confirm or cancel deletion of the results using symbols (2)
in this submode. Symbols status (2) changes with short presses of
RAYS/ RESTART. If "-On-" is displayed, it confirms clearing, if "-OFF" is
displayed, it means refusal from clearing. To exit this submode, press ON/SAVE. In
this case, the control unit switches to the mode of measurement results display
obtained from the probes or detectors.
Important! If the submode of measurement results clearing from the
nonvolatile memory is paused for more than 20 seconds (the user will not click any
button), the control unit automatically returns to the mode of measurement results
viewing stored in the nonvolatile memory.
Figure 2.38 – LCD of the dosimeter
78