ECOTEST MKS-UM Operating Manual page 53

the probes or detectors. If deletion was chosen, the control unit switches to the
submode of measurement object number programming.
Important! If this submode is paused for more than 20 seconds (the user will
not click any button), the control unit automatically returns to the mode of
"Measurement results display obtained from the probes or detectors".
2.3.6.5.4.2 Submode "Measurement object number programming"
The following information will be displayed on the LCD in this submode
(Figure 2.15):
- symbol (1) indicates the submode of measurement result saving in the
nonvolatile memory;
- "P" symbol (2) indicates a number of the object being measured;
- measurement object number (3);
- indicator of nonvolatile memory filling (4);
- symbol of the navigation receiver status (5);
- battery status symbol (6).
Important!
and before the oldest data is lost, there is a possibility to save not more than 10 new
results of DER measurements.
(submode of measurement result saving in the nonvolatile memory)
The low-order digit of the measurement object number will be blinking
indicating that its value can be programmed. By pressing RAYS/RESTART set the
required value of the blinking digit. Successive short presses and releases of
RAYS/RESTART change the value per unit. Pressing RAYS/RESTART for a
lomger time starts automatic change of the value that stops after RAYS/ RESTART
is released.
symbol (1) is blinking if almost all memory capacity is filled
Figure 2.15 – LCD of the dosimeter
51