Changing The Telephone Angle; Wall Mounting The Telephone - Nortel Meridian M3900 Reference Manual

74 Installation
Procedure 7
Change the telephone position
1
2
3

Changing the telephone angle

The M3901 and M3902 Meridian Digital Telephones have three
different angled height desktop positions.
Procedure 8
Change the telephone angle
1
2

Wall mounting the telephone

The telephone wall mount bracket kit contains a one-piece wall-mount
plate to attach the telephone to the wall using Procedure 9.
Procedure 9
Wall mount the telephone
1
2
3
4
5
6
555-4001-136 Standard 05.06 May 2002
Press the bar at the top back side of the telephone.
With the position bar pressed in, raise or lower the telephone to the desired
angle or height.
Release the bar to lock the telephone in the desired position.
This procedure is now complete
Move the top of the footstand away from the telephone base (it has a snap
connection).
Place the footstand in the desired position and snap the top of the footstand
back into place.
This procedure is now complete
Place the wall-mount bracket against the wall and mark the spot to insert the
screws.
Note: The M3901 and M3902 have built-in wall-mount brackets.
Screw the five screws in and leave about 3 1/2 mm (1/8 inch) between the
head of the screw and wall.
Remove the footstand from the telephone by sliding the footstand down
(using the plastic hinges) about 7 mm (1/4 inch).
Swing the footstand away from the telephone base and remove the
telephone.
Attach the wall-mount bracket onto the back of the telephone by placing the
telephone at the top edge of the wall-mount bracket and sliding the telephone
into place.
Mount the wall-mount bracket, that is attached to the telephone, onto the
screws located on the wall.
This procedure is now complete