Nortel Meridian M3900 Reference Manual page 89

Procedure 19
Set up the Personal Directory PC Utility interface
1 Insert the interface cartridge into either the small, or large, port on the ACM
in your M3904 or M3905 telephone set. The latch must be at the top.
2 Connect the personal computer to the M3904/M3905 telephone through a
RS-232C serial interface cable (see Table 21).
Table 21
RS-232-C pin to function description
Pin
2
3
4
5
6
20
7
Note: The user supplies the serial cable for the PC connection. One end
of the cable must be a DB25 pin connector and the other end must match
your computer serial port connection.
Procedure 20 describes how to install the Personal Directory PC Utility
software.
Procedure 20
Install the Personal Directory PC Utility software
1 Close all open applications before installing the Personal Directory PC Utility.
2 Insert the Personal Directory PC Utility disk into drive A.
Note: Assuming that drive A is the floppy disk drive.
3 Click on Start.
4 Select Run.
5 Enter a:\setup.
6 Click on OK. The Nortel Networks logo screen appears while the installation
utility loads.
7 The Welcome screen appears. Click on Next to continue installation.
8 If you agree to the terms of the Software License Agreement, click Yes.
Meridian SL-100 M3900 Meridian Digital Telephones Reference Guide
Function
TX
RX
RTS
CTS
DSR
DTR
SG
This procedure is now complete
Installation 89
Description
Transmit
Receive
Request to Send
Clear to Send
Data Set Ready
Data Terminal Ready
Single Ground Signal