CMOD-02 multifunction extension module (external 24 V AC/DC and isolated PTC
5
Motor thermistor connection
One to six PTC thermistors connected in
60
PTC IN
PTC connection
61
PTC IN
Ground (earth) potential
Mechanical installation
■
Necessary tools
•
Screwdriver and a set of suitable bits.
■
Unpacking and examining the delivery
1.
Open the option package. Make sure that the package contains:
•
the option module
•
a mounting screw.
2. Make sure that there are no signs of damage.
■
Installing the module
See section
Installing option modules (page
Electrical installation
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Stop the drive and do the steps in section
before you start the work.
■
Necessary tools
•
Screwdriver and a set of suitable bits
■
Wiring
Connect the external control cables to the applicable module terminals. Ground
the outer shield of the control cables 360° under the grounding clamp on the
grounding shelf
60
61
series.
1
Grounding screw
PTC IN
PTC IN
2
Hole for mounting screw
6
Diagnostic LED
115).
Electrical safety precautions (page 20)
interface) 279