CMOD-01 multifunction extension module (external 24 V AC/DC and digital I/O) 271
43
DO1 OUT
44
DO1 SGND
1) Digital output connection example
2) An externally supplied frequency indicator which provides, for example:
•
a 40 mA / 12 V DC power supply for the sensor circuit (CMOD frequency output)
•
suitable voltage pulse input (10 Hz ... 16 kHz).
Mechanical installation
■
Necessary tools
•
Screwdriver and a set of suitable bits.
■
Unpacking and examining the delivery
1.
Open the option package. Make sure that the package contains:
•
the option module
•
a mounting screw.
2. Make sure that there are no signs of damage.
■
Installing the module
See section
Installing option modules (page
Electrical installation
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Stop the drive and do the steps in section
before you start the work.
■
Necessary tools
•
Screwdriver and a set of suitable bits
■
Wiring
Connect the external control cables to the applicable module terminals. Ground
the outer shield of the control cables 360° under the grounding clamp on the
grounding shelf
Digital or frequency out-
put
Ground (earth) potential
54
RO5A
Normally closed, NC
55
RO5B
Normally open, NO
115).
Electrical safety precautions (page 20)