Table of Contents
Advertisement
Installation instructions
3.6 Connections
The picture below shows a machine with the feed direction from left to right. The
length of the infeed and outfeed and the number of washing and drying zones
vary depending on the size of the machine. The machine can also operate in the
opposite feed direction. For the exact location of the various connection points,
see the machine drawing located in the electrical cabinet.
7
7
1.
2.
3.
4.
5.
6.
7.
Check that the overheating protection device on booster heaters and tank heating
elements is reset to zero.
In the following chapter, figures are given in brackets to clarify what needs to be
done. These numbers refer to image and list above.
WD-B 550S - WD-B 950S
Electrical connection from ceiling
Alternative electrical connection from floor
Hot water connection (connection from floor or ceiling)
Cold water connection (connection from floor or ceiling)
Condensing water connection (option)
Steam connection (option, connection from floor or ceiling)
Floor drain 400x600 mm
20
1
4
3
6
5
2
7
5
6
4
3
7
1
Rev. (202209)
WDB_08_R2
Advertisement
Table of Contents
