Wexiodisk WD-B 550S Installation And User Manual page 22

Installation instructions
•
•
WD-B 550S - WD-B 950S
Join the ends of the conveyor belt if it is in position in the machine on
delivery (see drawing of the conveyor belt supplied with the dishwasher
documentation).
If the conveyor belt is delivered separately, it is fitted in the machine as
follows:
– Push in the belt on the upper track through the machine's outfeed
opening. Make sure that the belt is the right way up (see belt drawing).
- Pull the belt through the machine through to the infeed opening and
around the tension wheel.
- Tie a piece of rope to the end of the belt and pull the belt towards the
outfeed opening.
- Pull the belt around the outfeed drive wheel.
– Join the ends of the belt.
Tension the washing conveyor as follows:
C
C
A = Screw which locks the belt tensioner
B = Tension pulley
C = Adjuster screw
Loosen the belt tensioner screws (A).
– Tension the belt using the adjuster screws (C). When the belt is
sufficiently taught, it should be possible to lift it by about 5cm at the centre
of the infeed.
– Tighten belt tensioner screws (A).
18
B
A
35-1-00-013
Rev. (202209)