Table of Contents
Advertisement
Installation instructions
3.5 Installation
3.5.1 Preparing for the installation
3.5.2 General information
WD-B 550S - WD-B 950S
Check that there is sufficient room for the machine at the installation location.
•
Check that correct connections are available for water, electricity, drainage
and possibly steam at the installation location. See TECHNICAL
SPECIFICATIONS.
•
Check that the overheating protection device is reset.
Parts which must be assembled are prepacked inside each machine section
together with the necessary bolts, nuts, etc.
Remove all lower cover plates (5).
The final position of the machine is either free-standing in the room or placed with
the back against a wall. If the machine is to be placed against a wall, the assembly
should be carried out with sufficient space behind the machine for access during
the fitting of components on the back of the machine. The fully assembled
machine is then pushed into position.
The picture below shows a machine with the feed direction from left to right. The
picture shows parts which must be assembled during the installation and the
adjusting device for tensioning the washing conveyor. The length of the infeed
and outfeed section and the number of zones vary depending on the specific
machine. For this reason, the illustration below shows the approximate position
of the components in the machine.
1
2
8
7
Overview of dishwasher
1.
Adjuster screws for the washing conveyor
2.
Tension pulley
3.
Upper track
4.
Chain
9
6
10
12
Rev. (202209)
3
5
4
WDB-07_R01
Advertisement
Table of Contents
