Table of Contents
Advertisement
Installation instructions
WD-B 550S - WD-B 950S
•
Apply plenty of silicone around the openings of both sections and around
all screw holes; see the figure below.
The figure shows the application of silicone to section 1
A: Apply silicone around all screw holes
B: Apply a generous line of silicone along the centre of the lower contact surface
C: Apply silicone to all contact surfaces
•
Push the sections together. Hold them together with a screw clamp and fit
the bolts that hold the hoods together.
•
Wipe away any silicone that may have escaped when the sections were
pushed together.
•
Lock the stand on the front and rear sides of the machine using two screws
on each side.
D
C
E
B
Locking the stand
A = Leg
B = Joint in the stand
C = Stand
D = Screw
E = Connecting tube
C
A
B
35-1-00-006
A
Skarv
14
Rev. (202209)
Advertisement
Table of Contents
