Table of Contents
Advertisement
Installation instructions
WD-59CTS & WD-66CTS
•
Fit the overflow pipe between the chemical wash tank and final rinse tank.
The overflow pipe between the pre-wash tank and first chemical wash tank
is kinked in the middle. This ensures that water in the dishwasher flows as
intended. This is part of its design and not a fault.
Overflow pipe between the final rinse tank (on the left) and chemical wash tank
•
Check that the chain for moving the belt goes around the lower drive wheel
(the motor chain wheel).
•
Join the ends of the conveyor belt if it is in position in the machine on
delivery (see drawing of the conveyor belt supplied with the dishwasher
documentation).
If the conveyor belt is delivered separately, it is fitted in the machine as
follows:
– Push in the belt on the upper track through the machine's outfeed
opening. Make sure that the belt is the right way up (see belt drawing).
- Pull the belt through the machine through to the infeed opening and
around the tension wheel.
- Tie a piece of rope to the end of the belt and pull the belt towards the
outfeed opening.
- Pull the belt around the outfeed drive wheel.
– Join the ends of the belt.
17
Rev. (202210)
35-1-00-012
Advertisement
Table of Contents
