Table of Contents
Advertisement
Operating instructions
In addition to the faults shown on the touch panel, other faults can occur. The
table below shows some faults which can be rectified by the operator.
Troubleshooting
Problem
Noise from the washing
pump.
The machine is not
cleaning properly.
The dishware tips over.
Dishware does not dry.
All errors displayed on the touch panel have an error code, which is displayed in
the alarm. This error code must be specified when contacting service personnel.
When you contact service personnel, you will need to provide the following
information:
•
•
•
•
WD-59CTS & WD-66CTS
Cause
Foam in the tank.
For causes and actions, see "4.2.8 Checking the wash result".
The dishware is too light.
Washing pressure is too high.
The upper wash arms in the
chemical, pre-wash or final
rinse sections are clogged.
The rinse nozzles are blocked.
Too little drying agent.
Machine type and model.
Machine serial number and date when the machine was installed.
A brief description of the problem. Are any error codes shown on the touch
panel?
What happened/was being done immediately before the fault occurred?
48
Action
Change the water.
Put the dishware in baskets. Use a mesh grid to
hold the items in place.
If the machine is equipped with Quick setting for
washing pressure (option): Check that the lever
is set to the position for "Normal loads".
Clean the wash arms!
Check and clean the nozzles.
Check the quantity of drying agent.
Rev. (202210)
Advertisement
Table of Contents
