Table of Contents
Advertisement
Installation instructions
3.6.7 Drain/waste pipe
The waste water system connected to (7) should consist of a 50 mm metal pipe
that will withstand mechanical impacts. The waste pipe must run to a floor drain,
where its opening must be above the water level.
Ensure that the drain connection is kept in place by using e.g. cable ties in the
designated areas.
3.6.8 Detergent and drying agent
•
•
•
The equipment should preferably be mounted on a wall near the machine to avoid
unnecessary holes being drilled in the machine.
Contact your detergent supplier to arrange for the equipment to be installed.
For information about wiring diagram, see the machine's wiring diagram.
WD-59CTS & WD-66CTS
The machine has a drying agent connection and a water outlet for a
detergent device. The water outlet for detergent is located on the incoming
hot water pipe. The drying agent connection is on the pipe leading to the
booster heater for the final rinse water.
Use the same make and type of detergent and drying agent.
With machines connected to cold water, the water pipe temperature may
be too low for use of powder or paste type detergents.
23
Rev. (202210)
Advertisement
Table of Contents
