Assembly Of Sections - Wexiodisk WD-59CTS Installation And User Manual

Installation instructions
4.
5.
6.
7.
8.
9.
10.

3.5.3 Assembly of sections

•
•
•
Mounting the connecting tube
A = Leg
B = Stand
C = Lengthening joint
D = Screws
•
•
WD-59CTS & WD-66CTS
Chain
Cover plate
Drainage plate
Lower track
Belt tensioner
Cover plate
Overflow pipe
Remove any transport supports.
Position section 2 where you want it and adjust the height (see machine
drawing). Check that the section is horizontal using a spirit level on the tank
body. Adjust the machine using the legs.
Fit the lengthening joints to the stand on section 2.
D
C B
Position section 1 next to section 2 so that the rectangular metal pieces on
the stands of both sections are aligned. Check that section 1 is horizontal
using a spirit level on the tank body. Adjust using the legs.
Push section 1 against section 2 until the rectangular metal pieces on the
stand are pushed close to each other, but do not push the sections
completely together. There should still be a gap between them in order to
apply the silicone around the openings.
13
A
Skarvrör
Rev. (202210)