ZyXEL Communications EX3510-B1 User Manual page 99

devices must support WPS. It is recommended to use the Push Button Configuration (PBC) method if your
wireless client supports it. See
Note: The Zyxel Device applies the security settings of the main SSID (SSID1) profile (see
Section 7.2 on page
Note: If WPS is enabled, UPnP will automatically be turned on.
Note: The WPS switch is grayed out when WiFi is disabled.
Click Network Setting > Wireless > WPS. The following screen displays. Click this switch and makes it turn
blue. Click Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 58 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 26 Network Setting > Wireless > WPS
LABEL DESCRIPTION
General
WPS Click this switch to activate or deactivate WPS on this Zyxel Device. When the switch turns blue
, the function is enabled. Otherwise, it is not.
Add a new device with WPS Method
Method 1 Use this section to set up a WPS wireless network using Push Button Configuration (PBC). Click
this switch to make it turn blue. Click Apply to activate WPS method 1 on the Zyxel Device.
WPS Click this button to add another WPS-enabled wireless device (within wireless range of the Zyxel
Device) to your wireless network. This button may either be a physical button on the outside of
device, or a menu button similar to the WPS button on this screen.
Note: You must press the other wireless device's WPS button within two minutes of
Chapter 7 Wireless
Section 7.10.8.3 on page 113
89).
pressing this button.
EX3510-B1 User's Guide
99
for more information about WPS.