ZyXEL Communications EX3510-B1 User Manual page 83

Table 17 Network Setting > Broadband > Add/Edit New WAN Interface (Routing Mode) (continued)
LABEL DESCRIPTION
Select Manually Configured if you have the IPv4 address of the relay server. Otherwise, select
Automatically configured by DHCPC to have the Zyxel Device detect it automatically through
DHCP.
The Automatically configured by DHCPC option is configurable only when you set the method of
encapsulation to IPoE.
Service Provider Enter an IPv6 prefix for tunneling IPv6 traffic to the ISP's border relay router and connecting to the
IPv6 Prefix native IPv6 Internet.
IPv4 Mask Enter the subnet mask number (1~32) for the IPv4 network.
Length
Border Relay When you select Manually Configured, specify the relay server's IPv4 address in this field.
IPv4 Address
IPv6 IA_PD and IA_NA (This is available only when you select IPv4 IPv6 DualStack or IPv6 Only in the IPv4/IPv6 Mode
field.)
Prefix Click this switch to use DHCP PD (Prefix Delegation) which enables the Zyxel Device to pass the
Delegation IPv6 prefix information to its LAN hosts. The hosts can then use the prefix to generate their IPv6
addresses.
When the switch goes to the right
IPv6 Address Click this switch to obtain an IPv6 address from a DHCPv6 server. The IP address assigned by a
From DHCPv6 DHCPv6 server has priority over the IP address automatically generated by the Zyxel Device
Server using the IPv6 prefix from a Router Advertisement (RA).
When the switch goes to the right
WAN MAC Address (You can set the WAN MAC address in the following section.)
Factory Default Select Factory Default to use the factory assigned default MAC address.
Clone LAN Select this option to clone the MAC address of the computer (displaying in the screen) from
Host's MAC which you are configuring the Zyxel Device. It is advisable to clone the MAC address from a
Address computer on your LAN even if your ISP does not presently require MAC address authentication.
IP Address Enter the IP address of the computer on the LAN whose MAC address you are cloning.
Set WAN MAC Select this option to enter the MAC address you want to use.
Address
MAC Enter the MAC address you want to use.
Address
Cancel Click Cancel to restore the default or previously saved settings.
Apply Click Apply to save your changes.
Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon next to the
connection you want to configure. The following example screen displays when you select Bridge
mode.
Chapter 6 Broadband
, the function is enabled. Otherwise, it is not.
, the function is enabled. Otherwise, it is not.
EX3510-B1 User's Guide
83