ZyXEL Communications EX3510-B1 User Manual page 30

Table 5 Configuration Menus Summary (continued)
LINK TAB
Wireless General
Guest/More
APGuest/More
AP
MAC
Authentication
WPS
WMM
Others
Channel Status
MESH
Home LAN Setup
Networking
Static DHCP
UPnP
Additional
Subnet
STB Vendor ID
Wake on LAN
TFTP Server Name
Routing Static Route
DNS Route
Policy Route
RIP
QoS General
Queue Setup
Classification
Setup
Shaper Setup
Policer Setup
Monitor
Chapter 2 Web Configurator
FUNCTION
Use this screen to configure the WiFi settings and wireless LAN
authentication/security settings.
Use this screen to configure multiple BSSs on the Zyxel Device.
Use this screen to block or allow wireless traffic from wireless devices of
certain SSIDs and MAC addresses to the Zyxel Device.
Use this screen to configure and view your WPS (WiFi Protected Setup)
settings.
Use this screen to enable or disable WiFi MultiMedia (WMM).
Use this screen to configure advanced wireless settings.
Use this screen to scan WiFi channel noises and view the results.
Use this screen to enable
• AP steering which allows wireless clients to roam seamlessly between
Mesh supported devices in your Mesh network by using the same
SSID and WiFi password. Also, AP steering helps monitor wireless
clients and drop their connections to optimize the Zyxel Device
bandwidth when the clients are idle or have a low signal. When a
wireless client is dropped, it has the opportunity to steer to a Mesh
supported device with a strong signal, and
• band steering which allows dual-band wireless client devices, to use
the less-congested and higher capacity 5 GHz band, leaving the
more crowded 2.4 GHz band available for legacy clients.
Use this screen to configure LAN TCP/IP settings, and other advanced
properties.
Use this screen to assign specific IP addresses to individual MAC
addresses.
Use this screen to turn UPnP and UPnP NAT-T on or off.
Use this screen to configure IP alias and public static IP.
Use this screen to configure the Vendor IDs of the connected Set Top Box
(STB) devices, which have the Zyxel Device automatically create static
DHCP entries for the STB devices when they request IP addresses.
Use this screen to remotely turn on a device on the local network.
Use DHCP option 66 to identify a TFTP server name.
Use this screen to view and set up static routes on the Zyxel Device.
Use this screen to forward DNS queries for certain domain names through
a specific WAN interface to its DNS server(s).
Use this screen to configure policy routing on the Zyxel Device.
Use this screen to configure Routing Information Protocol to exchange
routing information with other routers.
Use this screen to enable QoS and traffic prioritizing. You can also
configure the QoS rules and actions.
Use this screen to configure QoS queues.
Use this screen to define a classifier.
Use this screen to limit outgoing traffic rate on the selected interface.
Use this screen to configure QoS policers.
Use this screen to view statistics of QoS on WAN/LAN interface and the
status of queues.
EX3510-B1 User's Guide
30