Table of Contents
Advertisement
Chapter 8 Static Route
8.2 Configuring Static Route
Use this screen to view and configure IP static routes on the Device. Click Network Setting >
Static Route to open the following screen.
Figure 75 Network Setting > Static Route
The following table describes the labels in this screen.
Table 35 Network Setting > Static Route
LABEL
Add New Static
Route
#
Destination IP
Gateway
Subnet Mask
Interface
Metric
Modify
8.2.1 Add/Edit Static Route
Click add new Static Route in the Routing screen or click the Edit icon next to a rule. The
following screen appears. Use this screen to configure the required information for a static route.
Figure 76 Routing: Add/Edit
116
DESCRIPTION
Click this to set up a new static route on the Device.
This is the number of an individual static route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets
to their destinations.
This parameter specifies the IP network subnet mask of the final destination.
This is the WAN interface through which the traffic is routed.
This is the "cost" of transmission for routing purposes.
Click the Edit icon to go to the screen where you can set up a static route on the
Device.
Click the Delete icon to remove a static route from the Device.
VMG1312-T10C User's Guide
Advertisement
Table of Contents
