Rip Settings - ZyXEL Communications EX3510-B1 User Manual

Table 44 Policy Route: Add/Edit (continued)
LABEL
Cancel
OK

9.5 RIP Settings

Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange routing
information with other routers.
Click Network Setting > Routing > RIP to open the RIP screen.
Figure 87 Network Setting > Routing > RIP
The following table describes the labels in this screen.
Table 45 Network Setting > Routing > RIP
LABEL
#
Interface
Version
Operation
Enable
Disable Default
Gateway
Cancel
Apply
Chapter 9 Routing
DESCRIPTION
Click Cancel to exit this screen without saving any changes.
Click OK to save your changes.
DESCRIPTION
This is the index of the interface in which the RIP setting is used.
This is the name of the interface in which the RIP setting is used.
The RIP version controls the format and the broadcasting method of the RIP packets
that the Zyxel Device sends (it recognizes both formats when receiving). RIP version 1 is
universally supported but RIP version 2 carries more information. RIP version 1 is
probably adequate for most networks, unless you have an unusual network topology.
Select Passive to have the Zyxel Device update the routing table based on the RIP
packets received from neighbors but not advertise its route information to other
routers in this interface.
Select Active to have the Zyxel Device advertise its route information and also listen for
routing updates from neighboring routers.
Select the check box to activate the settings.
Select the check box to set the Zyxel Device to not send the route information to the
default gateway.
Click Cancel to restore the default or previously saved settings.
Click Apply to save your changes back to the Zyxel Device.
EX3510-B1 User's Guide
145