Add/Edit Static Route - ZyXEL Communications P-660HN-51 User Manual

Figure 88 Advanced >Routing
The following table describes the labels in this screen.
Table 65 Advanced > Routing
LABEL
Add new Static
Route Entry
#
Status
Name
Destination IP
Subnet Mask
Gateway
Modify

15.2.1 Add/Edit Static Route

Use this screen to add or edit a static route. Click Add new Static Route Entry in the Routing screen or the
Edit icon next to the static route you want to edit. The screen shown next appears.
Figure 89 Routing: Add/Edit
Chapter 15 Routing
DESCRIPTION
Click this to configure a new static route.
This is the index number of the entry.
This field displays whether the static route is active or not. A yellow bulb signifies that
this route is active. A gray bulb signifies that this route is not active.
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This parameter specifies the IP network subnet mask of the final destination.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
Click the Edit icon to edit the static route on the Zyxel Device.
Click the Delete icon to remove a static route from the Zyxel Device. A window
displays asking you to confirm that you want to delete the route.
P-660HN-51 User's Guide
168