F-Series ID Camera Installation
1.3.11
Cable Glands and Spare Parts Kit
The kit contains the two 3/4" cable glands and gland
seal plugs required for non-conduit installations.
The remaining parts included in the kit are:
•
a spare ground wire
•
a spare ground nut and lock washer
•
two spare power terminal block plugs
•
two spare terminal block plugs
•
four spare F-Series back cover screws
1.3.12
Cable Gland Seal Inserts
The camera comes with two 3/4" NPT cable
glands, each with a three hole gland seal
insert. Cables may be between 0.23" to 0.29"
OD. Up to five cables may be needed. Plugs
are required for any insert hole(s) not used.
If non-standard cable diameters are used, you
may need to locate or fabricate the
appropriate insert to fit the desired cable. FLIR
Systems, Inc. does not provide cable gland
inserts other than the inserts supplied with the
system.
Note
Insert the cables through the gland seal before terminating and connecting them. The terminated
connectors will generally not fit through the cable gland. If a terminated cable is required, make a
clean, singular cut in the gland seal to install the cable into the gland seal.
427-0033-00-12 Version 110
Ground
Lug
GPIO Alarm
February 2019
This document does not contain any export-controlled information.
Camera Power
Heater Power
Seal plugs
Ethernet
10