FLIR F Series Installation Manual page 49

Advanced Configuration
Input/Output 0 is a control signal for the camera heater circuits. The Heater_GPIO44 output signal
performs internal functions and should not be changed.
The illustration at the right shows the default settings
for the input signal channel, Input/Output 1.
• The Label setting can be changed to reflect more
specific alarm information which can then appear in
VMS systems such as FLIR Latitude.
The GPIO Name determines the circuit point for
•
the GPIO driver and must not be changed.
Set GPIO Logic to Positive for a normally open
•
switch signal (circuit closes for alarm), Set GPIO
Logic to Negative for a normally closed switch
signal (circuit opens for alarm).
The illustration at the right shows the default
settings for the output signal channel, Input/Output
2.
• The Label setting can be changed to reflect
more specific alarm information which can then
appear in VMS systems such as FLIR Latitude.
• The GPIO Name determines the circuit point for
the GPIO driver and must not be changed. Set
an Initial Value (On or Off) for this output signal.
The Output Reset Interval is used to
•
automatically reset the output signal after a set
time. Setting the value to 0 prevents the output
from resetting automatically after a timeout. See also the Alarm Manager GPIO Output State
GPIO Output from Motion Alarm, pg.
Mode parameter,
• Set Alarm Output GPIO Logic to Positive for a normally open switch signal (circuit closes for
alarm), Set GPIO Logic to Negative for a normally closed switch signal (circuit opens for alarm).
Scroll to the bottom of the page and click on the Save
button to save changed settings. Changes will not take
effect until the server is stopped and started.
Alarm Manager, pg. 52
Refer to the
how to combine the GPIO inputs and outputs with
427-0033-00-12 Version 110
for a description of
February 2019
This document does not contain any export-controlled information.
Output duration
56.
Stop and Start Server
Click Save
49