FLIR F Series Installation Manual page 35

Advanced Configuration
By default, both streams use H.264 encoding. To modify parameters that affect a particular IP Video
stream from the camera, select the appropriate link (for example, Video - 0).
With the factory configuration, the default parameters provide high-quality full frame-rate video
streams with reasonable bandwidth usage. In general, for most installations it will not be necessary
to modify the default parameters. However in some cases, such as when a video stream is sent over
a wireless network, it may be useful to "tune" the video stream to try to reduce the bandwidth
requirements. In particular, the Encoding parameters described below.
Scroll down to save the changes through power cycles.
427-0033-00-12 Version 110 February 2019
This document does not contain any export-controlled information.
Streaming address
for VIDEO-0
Select analog
video format
35