FLIR F Series Installation Manual page 23

Basic Operation and Configuration
Services > Date and Time
The camera can be directed to an available NTP server that synchronizes all the system clocks on
the network or the date and time can be set manually for only the current camera.
Note
The server must be stopped before date and time settings can be saved.
NTP Mode: If your network uses an NTP server, select NTP and enter the NTP server information
(static IP or DHCP). Ensure that the NTP server can be found if it is public or located on a different
network.
Stop the server. The server must be stopped before date and time settings can be saved.
Click the Save button at the bottom of the page.
After the settings are saved, reboot the system. Refer to
Custom Mode: If the Custom mode is selected,
a pop-up window allows the information to be
entered manually.
Stop the server. The server must be stopped
before date and time settings can be saved.
Set the date and time parameters and click the
Save button at the bottom of the page.
After the settings are saved, restart the server.
Stop and Start Server
427-0033-00-12 Version 110 February 2019
This document does not contain any export-controlled information.
Server Status, pg. 27.
Select
Custom
Set Date
23