FLIR F Series Installation Manual page 41

Advanced Configuration
Global Settings
Click the settings icon
access Global Settings.
There are three settings for sensitivity which
control the threshold for detection (as well as
false alarms): Low, Medium, and High. When
set to low, the analytics will detect fewer
objects (also fewer false alarms) than when set
to high.
Set Show Regions to Yes to show any
detection areas as black boxes and tripwires
as black lines in the video.
The tracking display options are: All Boxes,
Classified Boxes, Show Triggered, and No
Boxes. If either option to show boxes is
selected, a check box enables a tracking line
with each detection box.
• All Boxes—every detected motion is shown with a box around it.
• Classified Boxes—detected motion classified as vehicle, human, or object of interest is shown
with a box around it labeled "H", "V", or "O".
• Show Triggered—detected motion that triggers an alarm is shown with a box around it.
• No Boxes—detected motion is not shown with a box.
• Lines—show the track of an object based on its position from prior frames. This helps to visually
represent speed and direction of motion (only available if All or Classified Boxes is selected).
• Tamper Sensitivity—enables the camera to alarm with tampering such as blocking, paint-
spraying, or obscuring the lens. The higher the value; the greater the sensitivity. The camera
interprets such events as ONVIF "Bad Video" and can react by sending ONVIF notifications.
When done, click Save, and then click the gear icon to return to the Analytics Setup page.
427-0033-00-12 Version 110
below the image to
February 2019
This document does not contain any export-controlled information.
41