Setting Of Cc-Link - Mitsubishi Electric NZ2GF-CCB User Manual

8.2.3

Setting of CC-Link

To start CC-Link, use the automatic CC-Link startup function and the slave station information saving function.
1.
Power on the module of the CC-Link remote station.
2.
Set the startup mode switch of the bridge module to AUTO.
3.
Power on the bridge module.
4.
Hold the startup mode switch in the SET position until the CC-Link RUN LED of the bridge module
turns off (about five seconds).
5.
Set the startup mode switch of the bridge module to PRM.
72