Mitsubishi Electric NZ2GF-CCB User Manual page 53

(5) T-branch connection
This section describes the method to configure the T-branch connection of the CC-Link system.
(a) T-branch system configuration
The following figure shows the system configuration for the T-branch connection.
Remote I/O station/
remote device station
(Branch line)
Terminating resistor
(DA-DB)
Remote I/O station/
remote device station
Remote I/O station/
remote device station
Remote I/O station/
remote device station
Up to six stations can be connected.
(Main line)
Bridge Remote I/O station/
remote device station
module
(Branch line)
Remote I/O station/
remote device station
The number of branch lines depends on the length of each branch line and
the total length of all the branch lines.
CHAPTER 6 INSTALLATION AND WIRING
(T-branch terminal
block/connector)
Remote I/O station/
remote device station
(Branch (Branch
line) line)
Remote I/O station/
remote device station
Remote I/O station/ Remote I/O station/
remote device station
remote device station
Up to six stations can be connected.
Terminating resistor
(DA-DB)
Remote I/O station/
remote device station
51
6