[Network] Menu; [Ethernet Type]; [Digital Link] - Panasonic PT-RQ25K Series Operating Instructions (Functional Manual)

[NETWORK] menu

On the menu screen, select [NETWORK] from the main menu, and select an item from the sub-menu.
Refer to "Navigating through the menu" (x page 102) for the operation of the menu screen.

[ETHERNET TYPE]

Set the transmission path of the Ethernet signal.
This can be set when the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) is installed in the slot.
The <DIGITAL LINK IN/LAN> terminal is a terminal equipped on the optional DIGITAL LINK Terminal Board
(Model No.: TY-SB01DL).
The <LAN> terminal is a terminal equipped on the projector as standard.
1) Press as to select [ETHERNET TYPE].
2) Press the <ENTER> button.
f The [ETHERNET TYPE] screen is displayed.
3) Press as to select an item.
[LAN]

[DIGITAL LINK]

[LAN & DIGITAL LINK]
4) Press the <ENTER> button.
Note
f When [ETHERNET TYPE] is set to [LAN], the Ethernet and serial control signals cannot be transmitted via the optional DIGITAL LINK output
supported device (Model No.: ET-YFB100G, ET-YFB200G) connected to the <DIGITAL LINK IN/LAN> terminal.
f The <DIGITAL LINK IN/LAN> terminal and the <LAN> terminal are connected inside of the projector when [ETHERNET TYPE] is set to
[LAN & DIGITAL LINK]. Do not directly connect the <DIGITAL LINK IN/LAN> terminal and the <LAN> terminal using a LAN cable. Construct
the system so that it is not connected to the same network via the peripherals such as the hub or the twisted-pair-cable transmitter.
[DIGITAL LINK]
Perform the setting and operation regarding the DIGITAL LINK.
This can be set when the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) is installed in the slot.
The <DIGITAL LINK IN/LAN> terminal is a terminal equipped on the optional DIGITAL LINK Terminal Board
(Model No.: TY-SB01DL).
[DIGITAL LINK MODE]
Switch the communication method of the <DIGITAL LINK IN/LAN> terminal.
1) Press as to select [DIGITAL LINK].
2) Press the <ENTER> button.
f The [DIGITAL LINK] screen is displayed.
3) Press as to select [DIGITAL LINK MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
[DIGITAL LINK]
[LONG REACH]
[ETHERNET]
Chapter 4 Settings — [NETWORK] menu
Select this item when using only the <LAN> terminal to transmit the Ethernet signal.
Select this item when using only the <DIGITAL LINK IN/LAN> terminal to transmit the Ethernet signal.
Select this item when using the <LAN> terminal and the <DIGITAL LINK IN/LAN> terminal to transmit
the Ethernet signal.
Switches the communication method automatically to DIGITAL LINK, long reach, or Ethernet.
Fixes the communication method to DIGITAL LINK.
Fixes the communication method to long reach.
Fixes the communication method to Ethernet.
ENGLISH - 219