Table of Contents
Advertisement
4)
Press the <ENTER> button.
f The [ACTIVE FOCUS OPTIMIZER] screen is displayed.
5)
Press as to select [FOCUS OFFSET SETUP].
6)
Press the <ENTER> button.
f The [FOCUS OFFSET SETUP] screen is displayed.
7)
Press as to select [INITIALIZE], and press the <ENTER> button.
f The confirmation screen is displayed.
8)
Press qw to select [OK], and press the <ENTER> button.
[LENS CALIBRATION]
Detect the lens adjustment limit value, and perform the calibration in the adjustment range. Execute the lens
calibration after attaching the projection lens.
Always execute the zoom calibration especially after attaching the Zoom Lens with the stepping motor.
Zoom Lens with the stepping motor
This section describes the operating procedure when the standard DC motor unit installed in the Zoom Lens
(Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20, ET-D75LE30, ET-D75LE40, etc.) is replaced
with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10), or when the Zoom Lens
with the stepping motor (Model No.: ET-D3LEW60, ET-D3LET80, ET-D3LEW10, ET-D3LES20, etc.) is attached.
1)
Press as to select [LENS].
2)
Press the <ENTER> button.
f The [LENS] screen is displayed.
3)
Press as to select [LENS CALIBRATION].
4)
Press the <ENTER> button.
f The [LENS CALIBRATION] screen is displayed.
5)
Press as to select an item.
[SHIFT/FOCUS/ZOOM]
[SHIFT/FOCUS]
[ZOOM]
6)
Press the <ENTER> button.
f The confirmation screen is displayed.
7)
Press qw to select [OK], and press the <ENTER> button.
f The lens calibration is started.
f To cancel, select [CANCEL].
Note
f Pressing the <FOCUS> button on the remote control for at least three seconds will display the confirmation screen for lens calibration
execution while [SHIFT/FOCUS/ZOOM] is selected in Step 5).
f Pressing the <ZOOM> button on the remote control for at least three seconds will display the confirmation screen for lens calibration
execution while [ZOOM] is selected in Step 5).
f [LENS CALIBRATION] cannot be executed when the [PROJECTOR SETUP] menu → [LENS] → [LENS TYPE] is set to [NOT SELECTED].
f [PROGRESS] is displayed in the menu during lens calibration. The operation cannot be canceled during calibration.
f [INCOMPLETE] is displayed when the lens calibration is not performed correctly.
f The origin position of the lens mounter and the home position of the projection lens are automatically updated when the lens shift calibration
is performed. The home position is an origin position of the lens shift (vertical position and horizontal position of the lens) based on the
calibration result. It does not match with the optical image center position.
f The home position varies depending on the projection lens type. For details, refer to "Lens shift range" (x page 92).
Chapter 4 Settings — [PROJECTOR SETUP] menu
Executes the calibrations for the lens shift, focus, and zoom.
After completing the calibration in the adjustment range, the projection lens will move to the home
position.
Executes the calibrations for the lens shift and focus.
After completing the calibration in the adjustment range, the projection lens will move to the home
position.
Executes the calibration of the zoom adjustment range.
ENGLISH - 177
Advertisement
Table of Contents
