Table of Contents
Advertisement
7)
Press as to select [LENS MEMORY DELETE].
8)
Press the <ENTER> button.
f The [LENS MEMORY DELETE] screen is displayed.
f The name of the saved lens memory and its lens position information ([VERTICAL POSITION]/
[HORIZONTAL POSITION]/[FOCUS POSITION]/[ZOOM POSITION]) are displayed in the [LENS MEMORY
DELETE] screen.
9)
Press as to select the item to delete, and press the <ENTER> button.
f The confirmation screen is displayed.
10) Press qw to select [OK], and press the <ENTER> button.
Note
f The numeric value information of the zoom position is displayed only in following cases.
g When the standard DC motor unit installed in the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20,
ET-D75LE30, ET-D75LE40, etc.) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10)
g When the Zoom Lens with the stepping motor (Model No.: ET-D3LEW60, ET-D3LET80, ET-D3LEW10, ET-D3LES20, etc.) is attached
Changing the lens memory name
1)
Press as to select [LENS].
2)
Press the <ENTER> button.
f The [LENS] screen is displayed.
3)
Press as to select [LENS MEMORY].
4)
Press the <ENTER> button.
f The [LENS MEMORY] screen is displayed.
5)
Press as to select [LENS MEMORY EDIT].
6)
Press the <ENTER> button.
f The [LENS MEMORY EDIT] screen is displayed.
7)
Press as to select [LENS MEMORY NAME CHANGE].
8)
Press the <ENTER> button.
f The [LENS MEMORY NAME CHANGE] screen is displayed.
f The name of the saved lens memory and its lens position information ([VERTICAL POSITION]/
[HORIZONTAL POSITION]/[FOCUS POSITION]/[ZOOM POSITION]) are displayed in the [LENS MEMORY
NAME CHANGE] screen.
9)
Press as to select the name to change, and press the <ENTER> button.
f The [LENS MEMORY NAME INPUT] screen is displayed.
10) Press asqw to select the text, and press the <ENTER> button to enter the text.
11) After the name is changed, press asqw to select [OK], and press the <ENTER> button.
f Saving of the lens memory is completed, and returns to the [LENS MEMORY NAME CHANGE] screen.
f If you press asqw to select [CANCEL] and then press the <ENTER> button, the changed name will not
be registered.
f If you press asqw to select [DEFAULT] and press the <ENTER> button, the changed name will not be
registered and the default name will be used.
f If you select [OK] without entering any characters and press the <ENTER> button, the default name will be
used.
Note
f The numeric value information of the zoom position is displayed only in following cases.
g When the standard DC motor unit installed in the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20,
ET-D75LE30, ET-D75LE40, etc.) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10)
g When the Zoom Lens with the stepping motor (Model No.: ET-D3LEW60, ET-D3LET80, ET-D3LEW10, ET-D3LES20, etc.) is attached
170 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Advertisement
Table of Contents
