Cautions When Setting Up The Projector - Panasonic PT-RQ25K Series Operating Instructions (Functional Manual)

Table of Contents

Advertisement

rProjection in all 360° direction is possible.
360°
360° vertically

Cautions when setting up the projector

f Install the projector in a place or with a mount that can sufficiently tolerate the weight. The position of the
projected image may shift if the strength is not sufficient.
f Use the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f The adjustable feet can be removed if not needed in the installation. However, do not use the screw holes
where the adjustable feet were removed for any other purpose such as fixing the projector to a mount.
Also, do not attach any screws not instructed in the operating instructions of the optional accessories into the
screw holes where the adjustable feet are removed. Doing so may damage the projector.
f When using the projector in any method other than the floor installation using the adjustable feet or ceiling
mounting installation using the Ceiling Mount Bracket, remove the four adjustable feet and use the six screw
holes (as shown in the figure) to fix the projector to a mount.
In such case, make sure that there is no clearance between the screw holes for ceiling mount on the projector
bottom and the setting surface by inserting spacers (metallic) between them.
f Use a torque screwdriver or Allen torque wrench to tighten the fixing screws to their specified tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
For the screws to fix the projector, use commercially available ISO 898-1 standard screws (made of carbon steel
or alloy steel).
(Screw diameter: M6, tapping depth inside the projector: 16 mm (5/8"), screw tightening torque: 4 ± 0.5 N·m)
Unit: mm
Adjustable feet
Adjustable feet
Positions of screw holes to fix projector and
adjustable feet
Chapter 1 Preparation — Precautions for use
360°
360° horizontally
Screw holes to fix the projector
M6
(combination of vertical and horizontal)
Thread engagement depth
Mount
16 (5/8")
360°
360° tilted
ENGLISH - 23

Advertisement

Table of Contents
loading

Table of Contents